Block producing node always stuck at "starting.." epoch is 0

Staking & Delegation Operate a Stake Pool
108

Tell me the reply number and I will edit

109

So… u can see now the relay on producer to IN peers?

110

59, 95, 97, 99

111

Hi Can you please help me to delete the above picture with my IP for security purpose, thanks a lot!

113

I don’t see this option yet

115

In 85 , there is no pic?

116

Hello, sorry just got off work.

I deleted pic.

117

Ok, u are fine now… tell me … did u checked? Now do u see the relay as IN peer on Producer?

118

Yes, I see relay as IN peer on producer. but I still don’t see my Relay IP on the topology.json
https://explorer.mainnet.cardano.org/relays/topology.json

In "logs/topologyUpdater_lastresult.json
I only see my own relay ip address and 9 msg
“resultcode”: “204”, “datetime”:“2021-03-25 01:22:05”, “clientIp”: “my relay ip”, “iptype”: 4, “msg”: “glad you’re staying with us” }

119

Thanks you

120

@Alexd1985 ,
Unfortunate after waiting 4 hours, I still do see my relay note IP on the tolopology.json!!
https://explorer.mainnet.cardano.org/relays/topology.json
thanks! That is one step closer

On the relay node, Processed TX is 0, On BP note processed TX is 5029, is it not enough time,
how long should it see processed TX?
thanks

121

Just wait… nodes will start to connect yours

122

Hi ,
Yesterday, I was try to install the grana tool on step 16, and after reboot, the BP node keep stuck at “starting” status.
I accidentally delete the vrf.skey , is it possible to regenerate without register the pool and certifcate again? I am desparate now …
thanks

123

Hi,
I use the original vrf.vkey to regenerate the vrf.skey, I manage to restart the mode, Is the pool need to be registered again or I it is just fine?

On relay node, I still see 0 processed TX, can you please see if my relay node function properly? I information I can check ?
thanks!

124

Check in glive… do u have IN peers?

125

I do have IN peers, but processed TX still 0

image

126

Do u have this line configured to true? Can u check in config file?

“TraceMempool”: true,

127

there is no TraceMempool in config.json file

Suddenly the (Relay) node server become very slow, could that be some problem with the node?

128

What do u mean there is no TraceMempool in config.json …

From where did u dowloaded the config file?

129

from the wget -N https://hydra.iohk.io/build/{NODE_BUILD_NUM}/download/1/{NODE_CONFIG}-config.json

The node is very slow now, I cannot even open file, is that an issue with the node, do you have any suggestion what can I do? will it happen to the node when a large number of node try to connect with it?

Config