As per the question, Total Tx of relay node and BP node is 0.
Even after reconfiguring the firewall port settings and topology port settings, it remained 0.
Peer Analysis also confirms the i and o of the BP IP+port.
Did I make a mistake in the settings somewhere?
Please help me.
check the topology updater logs, are u still use it to announce your present into the network?
you must see the message “glad you are staying with us…”
Alex, thank you for your reply.
When I checked, I saw a message that said “glad you’re staying with us.”
Using Peer Analysis, I can confirm the BP’s IP+Port as shown below.
when you set this node? If has less than 12/24 hours then its normal; probably you should wait more hours
I set up this node about 10-12 hours ago😅
I will wait 1-2 days as advised.