gLiveView states that the node is starting. However, I see that it now says Relay on top and it doesn’t seem to be able to connect others. Also, it doesn’t show the current standings of the blockchain.
@ahamomo I tried doing that multiple times. Both as writing as well as replacing the edited file with the original. It didn’t work - for some reason.
now u must wait few hours till the node will start… Mem RSS should reach 10,5G
this is happening first time after u upgraded to 1.35.3 version
you will see CORE MAINNET after the node will start
I was also in that state before. You’ll have to wait long enough (about 4 hours or Mem RSS is increased about 8GB) to see the status change from starting to percentage. After sync is complete your node will change automatically from Relay to Core if it is BP node.
The node was running on 1.35.3 (and made blocks on it). Does it still need that much time?
Will check back in a couple of hours. Thanks for the help all! I appreciate it a lot.
then I don’t know what happened there… if the db was locked… I thought it was possible to have more instances working… after the node will start then stop it and run again ./cnode.sh -d
then sudo systemctl enable cnode
sudo systemctl start cnode